I got 6040 1500kw water cold engraver 3 axis from china. Additional Information: I got a question? I am a dummy when it comes to cnc. Connect the 1Y pin from the hex inverter to the driver. Connect the CW terminal from the USB interface to the 1A pin on the hex inverter. Connect the GND pin from the USB interface to the GND pin on the hex inverter. The pin on the keyboard jog header can be used. First, go to this link and look at the chip diagram: Connect 5V from the USB interface tothe VCC pin. The use of the hex inverter in the application to invert a direction signal to have a motor run in the reverse directions is relatively simple. Gary Zeman, Sc.D., CHP Lawrence Berkeley National LaboratoryĬlick the link to add information to this solution: I AM TAKING THE FINAL YEAR PROJECT IN BASE STATIONS AND AIR INTERFACE. Report title: "A Local Government Official's Guide to Transmitting Antenna RF Emission Safety: Rules, Procedures, and Practical Guidance." The Local and State Government Advisory Committee (LSGAC) and the FCC have developed this guide to aid local governmental officials and citizens in understanding safety issues related to radiofrequency emissions from telecommunications towers. The report also contains practical guidance on application of provisions of the Telecommunications Act of 1996, which is the governing legislation regarding safety and siting of wireless telelcommunications facilities. This report contains charts and figures describing the characteristics and performance of telecommunications antennas. Recently FCC published an excellent report, cited below, to assist citizens and local governments dealing with siting of telecommuncations towers.
The FCC's Internet address is shown below. The Federal Communications Commission (FCC) is the primary federal agency responsible for safety aspects of modern-day wireless telecommunications systems.
0 kommentar(er)
